Тип техники
Бренд

Просмотр инструкции ламинатора Fellowes Saturn 2 A4, страница 5

Let our experts help you with a solution.

Customer Service...

www.fellowes.com

Always call Fellowes before contacting your place of purchase, see the rear cover for contact details.

NEED HELP?

Switch the power on (located at the rear of the machine).

The ‘Safe Start’ function will automatically select the cold setting.

For cold lamination, select the cold setting only.

For hot lamination, choose the pouch thickness setting as required. The ‘Wait’

symbol will flash during warm-up or cool-down periods.

When the machine is ready, the flashing ‘Wait’ symbol will stop flashing and

remain on. A signal will sound.

Place the document into the open pouch. Ensure the document is centred

against the sealed edge. Use the appropriate pouch size for the document.

Ensure the pouch enters the machine sealed edge first. Keep the pouch straight

and central within the slot, not on an angle. Use the entry markings as a

guide.

Upon exit, the laminated pouch may be hot and soft. To prevent jamming

remove the pouch immediately. Place pouch on to a flat surface to cool. Take

care when handling a hot pouch.

To release a pouch during lamination, activate the release lever located at the

rear of the machine. Gently pull pouch out of machine.

10.

11.

12.

Ensure the machine is on a stable surface.

Check there is enough clear space (min 50cm) behind the machine to allow

items to pass through freely.

Plug the machine into an easily accessible mains socket.

SETTING UP THE LAMINATOR

HOW TO LAMINATE

Switch off the machine at the wall. Allow the machine to cool. The outside of the machine can be cleaned with a damp cloth. Do not use solvents or flammable materials to

polish the machine. Cleaning sheets can be used with the machine. When the machine is warm – run the sheets through the machine to clean any residue off the rollers. For

optimum performance, it is recommended that cleaning sheets are used with the machine regularly. (Cleaning sheet order codes #5320601)

Problem Possible cause Solution

No control panel illumination Machine not switched on Switch on machine at rear next to plug inlet and at the wall socket

Pouch does not completely seal the item

Item may be too thick to laminate Check pass through thickness is correctly selected and pass through again

Temperature setting may be incorrect Check pouch thickness is correctly selected and pass through again

Pouch has waves or bubbles Temperature setting may be incorrect Check pouch thickness is correctly selected and pass through again

Pouch is lost in the machine Pouch is jammed

Operate the release lever and pull out the item by hand

Jamming

Pouch was used ‘open end’ first

Pouch was not centred on entry