Бесплатные инструкции на русском языке
  • Тип техники
  • Бренд

Просмотр инструкции холодильника Electrolux ERD 18001 W (W8), страница 39

Electrolux
electrolux 39
GB
Trouble shooting
How to change the bulb
Should the light fail to work you can
change it as below:
Break the circuit of the appliance.
Unscrew the screw holding the cover (1),
press the rear hook (2) and at the same
time slide the cover in the direction
indicated by arrow (3). So the bulb can
be replaced. (Bulb type: 230-240 V, 15
W, E 14 thread)
After changing the bulb replace the
cover, snap it in place, screw back the
screw and apply voltage to the appliance.
If something does not work
During operation of the appliance some
smaller but annoying trouble can often
occur, which does not require calling a
technician out. In the following chart
information is given about them to avoid
unnecessary charges on service.
We draw your attention that operation of
appliance goes with certain sounds
(compressor- and circulating sound). This
is not trouble, but means normal
operation.
We draw it to your attention again
that the appliance operates
discontinuously, so the stopping of
compressor does not mean being no-
current. That is why you must not touch the
electrical parts of the appliance before
breaking the circuit.
Problem
It is too warm in the
refrigerator.
It is too warm in the
freezer.
Possible cause
Thermostatic control can be set
wrongly.
If products are not cold enough or
placed wrongly.
The door does not close tightly or it
is not shut properly.
Thermostatic control can be set
wrongly.
The door does not close tightly or it
is not shut properly.
Products in big quantity to be frozen
were put in.
Products to be frozen are placed
too closely to each other.
Solution
Set the thermostat knob to higher
position.
Place the products to the
appropriate place.
Check if the door closes well and
the gasket is unhurt and clean.
Set the thermostat knob to higher
position.
Check if the door closes well and
the gasket is unhurt and clean.
Wait some hours and then check
the temperature again.
Place the products in a way so that
cold air could circulate among them.
Ваш отзыв будет первым
Задайте вопрос
Ваше имя
E-mail
Вопрос*
Ваш вопрос будет опубликован после проверки
Ваш вопрос опубликован