- Тип техники
- Бренд
Просмотр инструкции сварочного оборудования Fubag TS MIG 300 T PRO, страница 8
www.fubag.ru
Omperator's anual
- 7 -
10. Connection Gas System
-
-
-
Gas regulator in the attached accessories is installed and screwed firmly on the bottle to prevent
air leak.
Connect and firmly screw the two core plug of heater cable on the gas regulator to “Heater Socket”
on the rear board of welder.
Connect the one end of gas pipe in the attached accessories with the outlet of gas regulator and
firmly hold with hoop also in the attached accessories, the other end to “Gas Inlet” (gas valve joint)
on the back of wire feeder device.
Notice:
-
-
-
Must cut off the power before assemble/disassemble torch or replace the components.
The nozzle must be replaced in time on the condition that welding quality was influenced when it
burned to some extent. The distributor of torch must be replaced when it ruined.
The cable of torch must be replaced when it worn out.
SWITCH
HANDLE
STAND
GOOSENECK
SHUNT
CONTACT
TIP
CABLE
RUBBER LAYER
CONTROL CABLE
CORELESS CABLE
NYLON PIPE
WIRE
SPRING PIPE
NOZZLE
Ваш отзыв будет первым