- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 955
Section 03 ENGINES (2-STROKE)
Subsection 02 (443 AND 552 ENGINES)
A32CBEA
Install the MAG side heated bearing.
A32CBFA
All Engines
Bearings are pressed on crankshaft until they rest
against radius. These radius maintain the gap
needed for bearings lubrication.
When installing crankshaft, position drive pins
no. 6 as illustrated.
A03C1HA
1
TYPICAL
1. Drive pins
552 Engine
CAUTION: Use only the recommended Isoflex
grease (P/N 293 550 021). Make sure not to
push Isoflex grease between outside bearing
race and half crankcase.
NOTE: The 50 g tube corresponds to 50 cc of
grease.
Put27to32mLofgreaseinasyringe.
With the syringe, fill the PTO side ball bearings
with 27 to 32 mL of Isoflex grease as shown be-
low.
A32CBGA
All Engines
At seal no. 2 assembly, apply a light coat of lithium
grease on seal lip.
For bearing lubrication purpose, a gap of 1.0 mm
(.040 in) must be maintained between seals and
bearings.
mmr2005-011 81
Ваш отзыв будет первым