Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 70
Section 03 ENGINES
Subsection 01 (LEAK TEST)
LEAK TEST
SERVICE TOOLS
Description Part Number Page
hose pincher.........................................................................
295 000 076
........................................... 47
vacum/pressure pump kit.....................................................
529 021 800 ........................................... 47
PREPARATION
Use vacum/pressure pump kit (P/N 529 021 800)
to pressure test engine. The following gives verifi-
cation procedures for liquid cooled engines though
it also applies to fan cooled engines. For FC en-
gines, do not consider information pertaining to
coolant system and pump shaft oil gear reservoir.
On FC twin-cylinder engines, each cylinder cannot
be verified individually due to leakage from one
cylinder to the other through labyrinth sleeve in
center of crankshaft.
– Remove tuned pipe.
– Install plug over exhaust manifold.
– Remove carburetors/throttle body assembly (as
applicable).
– Unplug fuel inlet line from fuel rail.
– Insert plugs in intake rubber boots. Tighten
with existing clamps.
A33C19A
– Using a hose pincher (P/N 295 000 076), block
impulse hose.
– Install air pump on exhaust plug.
NOTE: If necessary, lubricate air pump piston with
mild soap.
CAUTION: Using hydrocarbon lubricant (such
as engine oil) will damage rubber seal of pump
piston.
mmr2005-068 47
Ваш отзыв будет первым