Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 697
Section05ELECTRICALSYSTEM
Subsection 05 (ACCESSORIES AND LIGHTING SYSTEM)
529 035 869
Connect the supply harness (P/N 529 035 869)
to diagnostic connector, located on right side of
the vehicle. Now the headlight and accessories
systems are supplied with 12 volts. Refer to
WIRING DIAGRAM section to troubleshoot light-
ing system.
CAUTION: Always use the proper supply har-
ness and cables. Ensure to respect polarity
when connecting cable clips to battery. Match
RED cables together.
Once lighting system testing is done, disconnect
supply cable from vehicle and then 12-Volt supply
from the supply cable.
12-VOLT POWER OUTLET
(cigarette-lighter type)
Removal
Remove the console.
Remove connectors from the power outlet hous-
ing.
Unscrew the large nut then remove the 12-Volt
power outlet.
Test
Remove power outlet.
Unplug the power outlet connectors.
Using the multimeter FLUKE 111 (P/N 529
035 868), measure the voltage between
RED/YELLOW and BLACK wires.
529 035 868
The obtained value should be between 12 and
14.5 Vdc.
– No voltage:
• Check accessories fuse (20 A), connectors
and wiring harness.
– Voltage is good:
• After checking the accessories, change the
power outlet.
Installation
The installation is the reverse of the removal pro-
cedure.
BEEPER (reverse alarm)
Removal
The beeper is located near the ignition coil.
Open the front hood, remove the windshield then
remove screws retaining the accessories panel.
Unplug connector from beeper.
Unscrew retaining ring then remove beeper.
Test
NOTE: Before testing the beeper, make sure the
connectors are installed on proper beeper tabs.
ENGINE TAB LOCATION
995 SDI engines
RED/GREY on positive tab
BEIGE/BLACK on negative tab
178 mmr2005-130
Ваш отзыв будет первым