- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 350
Section 08 DRIVE SYSTEM
Subsection 02 (DRIVE PULLEY)
Calibration screw has a notch on top of its head.
A16D0FA
1
1. Notch
Governorcuphas6positionsnumbered2to6.
Note that in position 1 there is no stamped number
(due to its location on casting).
See TECHNICAL DATA for original setting.
A16D0GA
1
1. Position 1 (not numbered)
Each number modifies maximum engine RPM by
about 200 RPM.
Lower numbers decrease engine RPM in steps of
200 RPM and higher numbers increase it in steps
of 200 RPM.
Example:
Calibration screw is set at position 3 and is
changedtoposition5. SomaximumengineRPM
is increased by about 400 RPM.
To Adjust:
Just loosen locking nut enough to pull calibration
screw
partially
out and adjust to desired position.
Do not completely remove the locking nut. Torque
lockingnutsto10N•m(89lbf•in).
CAUTION: Do not completely remove calibra-
tion screw otherwise its inside washer will fall
off.
CAUTION: Always adjust all 3 calibration
screws and make sure they are all set at the
same number.
A16D0HA
1
TYPICAL
1. Loosen just enough to permit rotating of calibration screw
338 mmr2005-087
Ваш отзыв будет первым