- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 323
Section 07 ELECTRICAL SYSTEM
Subsection 04 (ACCESSORIES)
ENGINE TYPE TAB LOCATION
All carburetor equipped
engines except Power
Tek
BEIGE/BLACK
on positive tab
BLACK on negative tab
SDI engines
RED/GREEN
on positive tab
BEIGE/BLACK on
negative tab
Power Tek
RED/YELLOW
on positive tab
BEIGE/BLACK on
negative tab
A32E3RA
2
1
1. GREEN/RED wire on positive tab
2. BEIGE/BLACKwireonnegativetab
Using jumper wires, connect battery positive post
to beeper positive tab.
Connect battery negative post to beeper negative
tab. See next photo.
CAUTION: To avoid beeper damage, ensure
that polarity is respected.
A32E3SA
1
2
TYPICAL — 12-VOLT BATTERY PLUGGED TO BEEPER
1. Beeper positive tab
2. Beeper negative tab
A continuous sound should be heard. If not, re-
place the beeper with a new one.
If the beeper is good, check connectors, fuse and
wiring harness.
Installation
To install beeper, reverse the removal procedure.
Check connectors position.
ENGINE TEMPERATURE GAUGE
Test
Fan-cooled Models
Check if the speedometer works properly.
Check connector and wiring harness.
Check the engine temperature sensor on engine.
If all other parts work properly, replace the engine
temperature gauge.
Liquid-cooled Models except SDI
Check fuses, connectors and harness.
Check condition of relay, refer to RELAY further in
this section.
Check temperature sensor on engine.
Replace temperature gauge.
SDI Models
Check fuse, connectors and harness.
Check the condition of relay 2 by using the BUDS
software.
mmr2005-085 309
Ваш отзыв будет первым