Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 259
Section 06 ENGINE MANAGEMENT (SDI)
Subsection 02 (DIAGNOSTIC PROCEDURES)
PCODE EMS PILOT LAMP BEEPER DESCRIPTION
P0264 BLINK OFF
Injector cyl. # 2 OR outer PTO injector
(2 cyl.), open circuit or shorted to ground.
P0268 BLINK OFF
Injector cyl. # 3 OR inner MAG injector
(2 cyl.), shorted to battery.
P0267 BLINK
OFF
Injector cyl. # 3 OR inner MAG injector
(2 cyl.), open circuit or shorted to ground.
P0271 BLINK
OFF Inner PTO injector shorted to battery.
P0270 BLINK
OFF
Inner PTO injector open circuit or shorted to
ground.
P0122 BLINK
OFF
Throttle position sensor voltage too low.
P0123 BLINK
OFF
Throttle position sensor voltage too high.
P0601 BLINK
OFF TPS learns unlikely or checksum fault.
P1102 BLINK
OFF
Throttle position sensor adaptation failure.
P1104 BLINK
OFF
Throttle position sensor adaptation canceled.
P1655 BLINK
OFF DESS
®
shorted to battery.
P1656 BLINK
OFF DESS
®
line shorted to ground.
P0604 BLINK
OFF
RAM fault.
P0605 BLINK
OFF EEPROM fault.
P0602 BLINK
OFF
MPEM not coded.
P0605 BLINK
OFF EEPROM checksum fault.
P0605 BLINK
OFF Coding ID checksum fault.
P0605 BLINK
OFF Coding checksum fault.
P0605 BLINK
OFF
Programming checksum fault.
P1549 BLINK
OFF
Very high exhaust temperature detected (1)
P0562
OFF
2 s beep/min.
Battery voltage too low.
P0563 BLINK 2 s beep/min. Battery voltage too high.
(1)
The beeper turns on when exhaust temperature is higher than 800°C (1472°F). When exhaust temperature
reaches 850°C (1562°F), engine speed is limited to 5250 RPM.
244 mmr2005-080
Ваш отзыв будет первым