- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1396
Section11BODY/FRAME
Subsection 01 (BODY)
BODY
INSTALLATION AND
ADJUSTMENT
HEADLAMP BEAM AIMING
Beam aiming is correct when center of high beam
is 25 mm (1 in) below the headlamp horizontal cen-
ter line, scribed on a test surface, 381 cm (12 ft
6 in) away.
Measure headlamp center distance from ground.
Scribe a line at this height on test surface (wall
or screen). Light beam center should be 25 mm
(1 in) below scribed line.
A02E0AA
1
B
90°
A
1. Headlamp center line
A. 381cm(12ft6in)
B. 25 mm (1 in) below center line
A02E07A
2
A
1
3
1. Headlamp horizontal
2. Light beam (high beam) (projected on the wall)
3. Light beam center
A. 25 mm (1 in)
Required Conditions
Place the vehicle on a flat surface perpendicular to
test surface (wall or screen) and 381 cm (12 ft 6 in)
away from it.
Rider or equivalent weight
must be on the vehicle.
Select high beam.
BULB REPLACEMENT
Headlamp
Tun d ra
If headlamp is burnt, tilt hood. Unplug connector
from headlamp. Remove protector cap and unfas-
ten bulb retainer clips. Detach bulb and replace.
1
A02E09A
TYPICAL
1. Retainers clips
Skandic LT/LT E
If headlamp bulb is burnt, tilt cab and unplug the
connector from the headlamp. Remove the rub-
ber boot and unfasten the bulb retainer ring. De-
tach the bulb and replace it with a new one. Prop-
erly reinstall parts.
A25H0JA
1
TYPICAL
1. Locking ring
mmr2005-055 541
Ваш отзыв будет первым