- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1319
Section08ELECTRICAL
Subsection 05 (ELECTRIC STARTER)
After placing collar no. 3 on armature shaft no. 11,
fit new snap ring no. 2 on armature shaft, then
make sure that it is properly secured.
Slide collar no. 3 over snap ring no. 2 and secure
in place by punching it at two or three places.
A03E0EA
1
2
4
3
1. Armature shaft
2. Snap ring
3. Collar
4. Punch
Starter Housing Assembly and
Starter Housing
Align previously traced indexing marks.
1
A32E21A
TYPICAL
1. Aligned indexing marks
Open brushes and slide over commutator.
Align end frame locating notch with yoke locating
protrusion and properly sit brush holder no. 13 into
housing no. 14.
1
A32E23A
1. Brush holder
To ease end frame installation, retain brush holder
with a small screwdriver while installing armature
assembly.
CAUTION: Make sure to place two end hous-
ings on a flat surface before tightening the
through bolts.
CAUTION: Make sure end frame fits perfectly
on yoke.
INSTALLATION
443 and 552 Engines
Make sure that starter and engine mating surfaces
are free of grime. Serious trouble may arise if
starter is not properly aligned.
CAUTION: Make sure that both starter brackets
are well seated against engine crankcase and
starter before torquing all retaining bolts.
Torque all M8 bolts to 24 ± 4 N•m(18±3lbf•ft).
Torque all M5 bolts to 5 ± 0.5 N•m(44±5lbf•in).
CAUTION: Before checking engaging depth of
starter pinon teeth, make sure that battery ca-
bles are disconnected.
Install starter.
NOTE: Check proper engaging depth of starter
pinion teeth to ring gear teeth (see illustration).
Install hardened washers (P/N 503 007 900) be-
tween engine and starter supports accordingly.
CAUTION: All starter bracket fasteners must be
secured with Loctite 271 (P/N 293 800 005).
460 mmr2005-046
Ваш отзыв будет первым