- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1317
Section08ELECTRICAL
Subsection 05 (ELECTRIC STARTER)
Brush Holder
Check the brush holder for insulation using
growler test probes. Place one test probe on the
insulated brush holder and the other test probe
on the brush holder plate. If the growler lamp
turns on, the brush holder has to be repaired or
replaced.
Brush Length
Measure brush length. If less than the specified
value, replace them.
LENGTH
MODEL
NEW WEAR LIMIT
All 10 mm (.400 in) 6 mm (.236 in)
A03E05A
1
2
TYPICAL
1. New
2. Wear limit
End Housing
593 and 593 HO SDI Engines
Check the mica insulation of the positive brush
and also the roller bearing condition. Replace, if
required.
1
2
A32E22A
1. Roller bearing
2. Positive brush
Overrunning Clutch
The pinion of the overrunning clutch should turn
smoothly in a clockwise direction, and should not
slip in a counterclockwise direction. If defective,
replace.
Check the pinion teeth for wear and damage. If
defective, replace.
Starter Relay
Inspect connections and clean as necessary. Re-
lay condition can be checked with an ohmmeter.
Install test probes on large connectors of relay
when it is activated ((+) on RED/GREEN wire and
(-) on relay body for the fan cooled models and (-)
on the BLACK wire for liquid cooled models).
IMPORTANT: No current must be present on large
cables when using ohmmeter, otherwise meter
could be damaged.
ASSEMBLY
443 and 552 Engines
Prior to assembling, coat sliding surfaces and
moving parts on armature shaft splines, overrun-
ning clutch, relay plunger, drive lever and bushings
with synthetic grease (P/N 413 711 500).
Proceed as follows for assembly.
Install overrunning clutch onto armature shaft. In-
sert inner collar onto shaft. Install a new circlip.
CAUTION: Always install a new circlip when
servicing.
458 mmr2005-046
Ваш отзыв будет первым