- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1228
Section 07 TRANSMISSION
Subsection 02 (DRIVE PULLEY)
5,6,18,19, Fixed Half, Sliding Half,
Spring, Spring Cover and Screw
To install spring cover, use pulley spring compres-
sor (P/N 529 035 524).
Assemble fixed and sliding halves. Note that fixed
halves have different cone angle. Match cone an-
gle with crankshaft.
Lift sliding half against spring cover and align
spring cover arrow with sliding half mark.
1
A32D1YA
1. Align
Tighten screws to proper torque as mentioned in
exploded view.
6,25,29, Sliding Half, Slider Shoe
and Governor Cup
To install governor cup, use following tool:
A16B01A
529 005 500
Insert spring and slider sho
es into governor cup
so that groove in each slid
er shoe is vertical to
properly slide in guide
s.
CAUTION: Make sure O-rings are installed on
slider shoes and that grooves are positioned
vertically.
Install fork (P/N 529 005 500) into slider shoe
grooves to maintain them for governor cup instal-
lation. Proceed on 3 set of slider shoes.
A16B02A
529 005 500
TYPICAL
Make sure to align governor cup arrow with sliding
half and fixed half mark.
TRA III
NOTE: If fixed half has no mark, align governor cup
mark with segment no. 1 of inner half. Segments
areidentifiedonengineside.
A16D0EA
1
TYPICAL
1. Align
Carefully slide governor cup into sliding half. Align
mark of governor cup with mark of fixed half.
Remove forks and push governor cup so that its
splines engage with fixed half shaft splines.
364 mmr2005-035
Ваш отзыв будет первым