- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1115
Section 04 ENGINE (4-TEC)
Subsection 07 (CRANKCASE)
GENERAL
To remove crankcase, the engine removal is nec-
essary.
For installation, use the torque values and Loctite
products indicated in the exploded view. Clean
threads before using Loctite when installing
screws.
PTO COVER
Removal
Remove:
– engine from the vehicle (refer to REMOVAL
AND INSTALLATION)
– oil tank (refer to LUBRICATION SYSTEM)
– disconnect crankshaft position sensor no. 23
– PTO cover screws no. 17 and no. 17A and pull
PTO cover no. 16.
1
R1004motr111A
3
2
1. PTO cover
2. PTO cover screws
3. Crankshaft position sensor
Inspection
Check the PTO cover for cracks or other damage.
Replace PTO cover if damaged.
Check plain bearings no. 18 and no. 19 for scor-
ings or other damages.
NOTE: Measure plain bearing inside diameter
and compare to crankshaft journal diameter (PTO
support bearing). Refer to CRANKSHAFT/DRIVE
GEARS. Replace if the measurement is out of
specification.
2
R1004motr112A
A
1
1. Plain bearing
2. Oil bore
A. Plain bearing inside diameter to be measured in area of oil bore
PLAIN BEARING INSIDE DIAMETER
(PTO SIDE SUPPORT BEARING)
Service limit 38.040 mm (1.4976 in)
Bearing Removal Procedure
Carefully remove the oil seal no. 20 with a screw-
driver, without inflicting damage to the PTO cover.
TOOLS P/N TO REMOVE PTO SIDE
PLAIN BEARING
PTO side plain bearing
remover
529 035 914
NOTE: Carefully push-out the plain bearings
no. 18 and no. 19 from the outside towards the
inside. The PTO cover has to be supported from
below with suitable support with straight surface,
in order to prevent damage of the sealing surface.
2
R1004motr113A
1
1. PTO cover
2. Plain bearing remover (P/N 529 035 914)
mmr2005-027 249
Ваш отзыв будет первым