- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1095
Section 04 ENGINE (4-TEC)
Subsection 05 (CYLINDER AND CYLINDER HEAD)
2
R1004motr106A
1
3
A
B
1. First measuring diameter in line with cylinder bottom
2. Second measuring diameter
3. Third measuring diameter
A. 60 mm (2.362 in)
B. 50 mm (1.968 in)
CYLINDER TAPER
MAXIMUM (NEW)
0.038 mm (.001 in)
SERVICE LIMIT 0.090 mm (.004 in)
Difference between measurements should not
exceed the service limit mentioned above.
Cylinder Out of Round
Measure cylinder diameter in piston axis direction
from top of cylinder. Take another measurement
90° from first one and compare.
NOTE: Take the same measuring points like de-
scribed in CYLINDER TAPER above.
R1004motr107A
B
A
A. Paralleltopistonaxis
B. Perpendicular to piston axis
CYLINDER OUT OF ROUND
MAXIMUM (NEW) 0.01 mm (.0002 in)
SERVICE LIMIT
0.02 mm (.0008 in)
CAUTION: Always replace gasket no. 1 before
installing the cylinder.
Installation
For installation, reverse the removal procedure.
Pay attention to the following details.
NOTE: The cylinders are not identical in design.
Do not invert the cylinders during assembly.
First mount cylinder 1. Then remove the crank-
shaft locking tool (P/N 529 035 900). Crank the
engine further and position piston 2 at TDC. Mount
cylinder 2. The cylinder cannot be pushed fully
over the piston unless the piston is located at TDC.
Apply engine oil in the bottom area of the cylinder
bore and also on the band of the piston ring com-
pressor tool.
Using a piston ring compressor plier, such Snap-
On RC-980, slide piston into cylinder.
R1004motr108A
228 mmr2005-025
Ваш отзыв будет первым