- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1010
Section 03 ENGINES (2-STROKE)
Subsection 06 (OIL INJECTION SYSTEM)
3, Screw
Torque to 5 N•m(44lbf•in).
Cable plastic elbow must be fastened and fully
inserted.
Make sure cable barrel is well seated in oil pump
lever.
Secure barrel with plastic washer and circlip.
Install cable lock washer on lever side.
Verify cable and oil pump lever operation.
2, Check Valve
593 and 593 HO SDI Engines
Apply Loctite 648 (green) (P/N 413 711 400) on
the outer diameter of the check valve (machined
section). Take care that Loctite is ONLY in this
area.
NOTE: Prior to coating it with Loctite, make sure
check valve body is clean and dry. Clean from dirt
or oil, if any, with pulley flange cleaner (P/N 413
711 809).
A32C57A
APPLY LOCTITE ON THIS AREA ONLY
Install the check valve in the correct position as
described on next photo into the crankcase lower
side.
A32C58A
A
B
POSITION FOR 593 ENGINE
A. PTO side: 30° ±10° from cylinder axis to the bottom
B. MAG side: 0° from cylinder axis to the top
A32C59A
A
B
TYPICAL — POSITION FOR 593 HO SDI ENGINE
A. PTO side 45° ±5° from cylinder axis to the top
B. MAG side 20° ±5° from cylinder axis to the bottom
Punch in the check valve carefully with a plastic
hammer.
Clean the crankcase from surplus of Loctite 648
with a rag.
ADJUSTMENT
Prior to adjusting the pump, make sure all car-
buretor adjustments are completed and engine is
stopped.
277, 443 and 552 Engines
Eliminate the throttle cable free-play by pressing
the throttle lever until a light resistance is felt, then
hold in place.
The mark on the pump casting and on the lever
must align. Width of lever mark is the tolerance.
138 mmr2005-015
Ваш отзыв будет первым