- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1001
Section 03 ENGINES (2-STROKE)
Subsection 05 (MAGNETO SYSTEM)
A03C1JB
420 876 080
1
TYPICAL
1. 30 mm socket
To remove magneto flywheel, install crankshaft
protector (P/N 420 876 557) on crankshaft end.
Screw magneto puller (P/N 529 035 547) into
puller ring.
Tightenpullerboltandatthesametime,tapon
bolt head using a hammer to release magneto fly-
wheel from its taper.
Stator
NOTE: Always check stator no. 6 before changing
it, refer to TESTING PROCEDURE.
Remove:
– magneto flywheel no. 3
– all Allen socket screws retaining stator to mag-
neto housing
– grommet from crankcase where trigger coil and
stator wires exit magneto housing.
Unplug the trigger coil connectors and pull the
wires through the grommet location.
NOTE: To pass the stator connector into the grom-
met location it is necessary to pass the trigger coil
connector first.
Unplug the stator connector and remove the sta-
tor.
Trigger Coil
Magneto and stator no. 6 must be removed be-
fore trigger coil removal.
To replace trigger coil no. 5:
– Disconnect trigger coil connector housing.
– Remove grommet from crankcase where trig-
ger coil wire exits magneto housing.
– Remove retaining screws no. 4.
– Remove trigger coil and carefully pull wires.
– Install new trigger coil and other parts removed.
ASSEMBLY
Trigger Coil
For installation, reverse the removal procedure.
NOTE: It is important to remove the old silicon at
trigger coil location then apply new silicon. Screw
trigger coil then stick the trigger coil wires in the
silicon.
Stator
Make sure to position stator no. 6 in a way that its
wire protectors are over recess of crankcase.
1
A32E0KA
2
1. Crankcase recess
2. Wire protectors
Apply Loctite 243 (P/N 293 800 060) on threads
of stator screws then torque them to 9 N•m
(80 lbf•in).
Reinstall all other removed parts.
Magneto Flywheel
Clean crankshaft extension (taper) and apply Loc-
tite 243 (blue) on taper, then position Woodruff
key, magneto flywheel no. 3 and lock washer on
crankshaft.
mmr2005-014 129
Ваш отзыв будет первым