- Тип техники
- Бренд
Просмотр инструкции квадроциклы Can Am DS 70 2011, страница 100
MAINTENANCE PROCEDURES
vmo2008-008-047_a
TYPICAL
1. Chain adjuster
2. Chain adjuster lock nut
3. Chain adjuster nut
The drive chain deflection should
be between 44 mm to 57 mm
(1.7 in to 2.2in) up and down.
V06H06Y
FREE-PLAY: 44 MM TO 57 MM
(1.7IN TO 2.2 IN)
7. When properly adjusted, tighten
chain adjuster lock nut.
8. Then, tighten drive axle lock-
ing bolts to 69 N•m ± 7 N•m
(51lbf•ft±5lbf•ft).
9. On models equipped with a chain
tensioner, release the chain ten-
sioner back onto the chain.
Tires and Wheels
Tire Pressure
WARNING
Tire pressure greatly affects ve-
hicle handling and stability. Low
pressure may cause tire to deflate
and rotate on wheel. Overpres-
sure may burst the tire. Always
follow recommended pressure.
Sincetiresarelow-pressuretypes,
a manual pump should be used.
Check pressure when tires are cold
before using the vehicle. Tire pres-
sure changes with temperature and
altitude. Recheck pressure if one of
these conditions has changed.
For your convenience, a pressure
gauge is supplied in the tool kit.
TIRE PRESSURE
FRONT AND REAR
MINIMUM
25 kPa (3.6 PSI)
MAXIMUM
35 kPa (5 PSI)
Although the tires are specifically de-
signed for off-road use, a flat may still
occur. Therefore, it is recommended
tocarryatirepumpandarepairkit.
Tire and Wheel Condition
Occasionally, wheel bolts should be
removed to apply anti-seize lubricant
to ease future removal. This is particu-
larly important when vehicle is used in
a salt-water environment or in mud.
Remove one nut at a time, lubricate it,
then install and retorque it.
Check tires and rims for damage and
wear.
Replace if necessary.
98
______________
Ваш отзыв будет первым