- Тип техники
- Бренд
Просмотр инструкции автомагнитолы Hyundai Electronics H-CMD4030, страница 12
12 13
Operation Operation
unit. This enables to adjust the volume and
quality of the sounding. For example, you can
connect an MP3-player to listen to tracks using
the car acoustic system.
Radio operations
Band selection
Press repeatedly BAND button on the panel
or RDM/BAND button on the RC to select your
desired radio band in RADIO mode: FM1 - FM2
- FM3 (OIRT) – MW1 (AM1) - MW2 (AM2). In
each set of the bands you can store up to 6
preset stations, making total 30 preset memory
stations.
Manual/automatic tuning
• Manual tuning: Press and hold SEEK- /
SEEK+ buttons on the RC to enter manual
tuning mode. MANUAL will be displayed.
Press these buttons repeatedly to change the
frequency upward or downward step by step.
• Automatic tuning: Press repeatedly
SEEK- /SEEK+ buttons on the RC or
press and hold these buttons on panel to start
automatic seeking for an available radio station
downward or upward. After being found the
station will be played. To stop seeking, press
one of these buttons again.
Programming preset stations
• There are 6 numbered preset buttons on
the RC, with which you can store and recall
stations for each band (18 FM, 6 AM). Select
a station, then press and hold a preset button.
The station will be saved in the memory under
the corresponding number. To recall a stored
station, press the corresponding preset button.
• You also can save stations in the memory
with MEM button on the front panel. When
the needed frequency is found, press MEM,
then rotate VOLUME knob to select a memory
position (Preset 1 - 6) and press OK button to
confirm saving.
Auto memory store/Preset scan
Auto store: Select a band, press and hold
P.SCN/RPT button on the RC to enter auto
store mode. The radio will automatically store 6
stations to the 6 preset memories of the current
band. To stop auto store, press the button again.
During auto station preset, the unit will
search and store stations with the strong signal
first, and then weaker signal stations until the
memories are full.
Preset scan: Select a band, press P.SCN/
RPT button on the RC to scan all preset
stations in the memories of the current band.
To stop preset scan, press the button again.
Stereo/Mono reception
In FM mode, press STEREO/MONO button
on the RC to select stereo or mono signal
reception mode.
On-screen display
Press OSD button on the RC to show
enabled PTY function icon.
RDS function
RDS (Radio Data System) service availability
varies with areas. Please understand if RDS
service is not available in you area, the
following service is not available, either.
AF (Alternative frequencies) function
Press and hold AF/TA button on the RC
or MENU button on the panel to enable AF
function. When the radio signal strength is poor,
enabling the AF function will allow the unit to
automatically search another station with the
same PI (Program Identification) as the current
station but with stronger signal strength.
AF indicator on the display will flash until
RDS information is received. If RDS service is
not available in your area, turn off the AF mode.
TA (Traffic alarm) function
Press AF/TA button on the RC or press and
hold OK button on the panel to activate the
traffic alarm function.
Ваш отзыв будет первым