- Тип техники
- Бренд
Просмотр инструкции плиты Indesit KNJ 3G207 (W), страница 18
18
GB
A
V
! If one or more of these cond itions is not fulfilled or
if the cooker must be installed ac cording to the
conditions listed for class 2 - subclass 1 appliances
(installed between two cupboards), the flexible steel
hose must be used instead (
see below
).
Connecting a flexible jointless stainless steel pipe
to a threaded attachment
Make sure that the hose and gaskets comply with
current national legislation.
To b eg in using the hose, remove the hose holder on the
ap p lianc e (the gas sup p ly inlet on the app lianc e is a
cylind rical threaded 1/2 gas male attachment).
! Perform the connec tion in such a way that the hose
length does not exceed a maximum of 2 metres,
making sure that the hose is not compressed and
does not come into contact with moving parts.
Checking the connection for leaks
When the installation process is complete, check
the hose fittings for leaks using a soapy solution.
Never use a flame.
Adapting to different types of gas
It is possible to adapt the appliance to a type of gas
other than the default type (this is indic ated on the
rating label on the cover).
Adapting the hob
Replacing the nozzles for the hob burners:
1. Remove the hob grids and slid e the burners off
their seats.
2. Unscrew the nozzles using a
7 mm socket sp anner (
see
figure
), and replac e them with
nozzles suited to the new type
of g as(
see Burner and nozzle
specifications table
).
3. Replace all the components
by following the above
instructions in reverse.
Adjusting the hob burners’ minimum setting:
1. Turn the tap to the minimum position.
2. Remove the knob and adjust the regulatory
screw, which is positioned inside or next to the tap
pin, until the flame is small but steady.
! If the app liance is connec ted to a liquid gas
supply, the regulatory screw must be fastened as
tightly as possible.
3. While the b urner is alight, q uickly c hang e the position
of the knob from minimum to maximum and vic e versa
several times, chec king that the flame is not
extinguished.
! The hob burners d o not require p rimary air adjustment.
Adapting the oven
Replacing the oven burner nozzle:
1. Remove the oven compartment.
2. Slide out the protec tion
p anel A
(
see diagram
).
3. Remove the oven burner
after unscrewing the screws V
(
see figure
).
The whole op eration will b e
made easier if the oven d oor
is removed.
4. Unscrew the nozzle using a
special nozzle socket spanner
(
see fig ure
) or with a 7 mm
socket spanner, and replace it
with a new nozzle that is
suited to the new type of gas
(
s ee Burner and nozzle
specifications table
).
Adjusting the gas oven burner’s minimum setting:
1. Light the b urner (
see Start-up and Use
).
2. Turn the knob to the minimum position (MIN) after
it has been in the maximum position (MAX) for
approximately 10 minutes.
3. Remove the knob.
4. Tighten or loosen the adjustment sc rews on the
outside of the thermostat pin (
see figure
) until the
flame is small but steady.
! If the appliance is c onnected to liquid gas, the
adjustment screw must be fastened as tightly as
possible.
Ваш отзыв будет первым