Бесплатные инструкции на русском языке
  • Тип техники
  • Бренд

Просмотр инструкции микроволновой печи Gorenje CMO-200 DW, страница 50

Gorenje
50
a) Clean the door and sealing surface of the oven.
b) Place the radio, TV, etc. as far away from your microwave oven as possible.
c) Use a properly installed antenna for your radio, TV, etc. to get a strong signal
reception.
INSTALLATION
1. Make sure all the packing materials are removed from the inside of the door.
2. Inspect the oven after unpacking for any visual damage such as:
- Misaligned Door
- Damaged Door
- Dents or Holes in Door Window and Screen
- Dents in Cavity
- If any of the above are visible, DO NOT use the oven.
3. This Microwave Oven weighs 10.5 kg and must be placed on a horizontal
surface strong enough to support this weight.
4. The oven must be placed away from high temperature and steam.
5. DO NOT place anything on top of the oven.
6. Keep the oven at least 8 cm away from both sidewalls and 10 cm away from
rear wall to ensure the correct ventilation.
7. DO NOT remove the turn -table drive shaft.
8. As with any appliance, close supervision is necessary when used by children.
WARNING
- THIS APPLIANCE MUST BE EARTHED.
The plug socket should be within easy reach of the power cord
This oven requires 1.1 KVA for its input, consultation with service engineer is
suggested when installing the oven.
CAUTION:
This oven is protected internally by a 250V 8 Amp Fuse.
IMPORTANT
- The wires in this mains lead are colored in accordance with the
following code:
Green-and-yellow Earth
Blue Neutral
Brown Live
As the colors of the wires in the mains leads of the appliance may not
correspond with the colored markings identifying the terminals in your plug,
proceed as follows:
The wire which is colored green-and-yellow must be connected to the terminal
in the plug which is marked with the letter
E
or by the earth symbol colored
green of green-and-yellow.
The wire which is colored blue must be connected to the terminal which is
marked with the letter
N
or colored black. The wire which is colored brown must
be connected to the terminal which is marked with the letter
L
or colored red.
Ваш отзыв будет первым
Задайте вопрос
Ваше имя
E-mail
Вопрос*
Ваш вопрос будет опубликован после проверки
Ваш вопрос опубликован