- Тип техники
- Бренд
Просмотр инструкции видеокамеры Sony DCR-IP55E, страница 241
241
Troubleshooting/Поиск и устранение неисправностей
If you run into any problem using your camcorder, use the following table to troubleshoot the
problem. If the problem persists, disconnect the power source and contact your Sony dealer. If
“C:ss:ss” appears on the LCD screen, the self-diagnosis display function has activated. See page
248.
In the recording mode
Symptom Cause and/or Corrective Actions
• The POWER switch is not set to CAMERA.
c Set it to CAMERA (p. 39).
• The tape has run out.
c Rewind the tape or insert a new one (p. 35, 59).
• The write-protect tab is set to expose the red mark.
c Use a new cassette or slide the tab (p. 36).
• The tape is stuck to the drum (moisture condensation).
c Remove the cassette and leave your camcorder for at least
one hour to acclimatise (p. 270).
• When your camcorder is in the recording standby mode for
more than five minutes, the camcorder automatically turns off
to save battery power and to prevent battery and tape wear.
c Set the POWER switch to OFF (CHG) and then to ON.
• The battery pack is dead or nearly dead.
c Install a fully charged battery pack.
• The viewfinder lens is not adjusted correctly.
c Adjust the viewfinder lens (p. 43).
• STEADYSHOT is set to OFF in the menu settings.
c Set it to ON in the menu settings (p. 226).
• The setting is the manual focus mode.
c Press FOCUS to set to the auto focus mode (p. 87).
• Shooting conditions are not suitable for autofocus.
c Adjust to focus manually (p. 87).
• The LCD panel is open.
c Close the LCD panel when you record using the viewfinder
(p. 41).
• The contrast between the subject and background is too high.
This is not a malfunction.
• This is not a malfunction.
• SLOW SHUTTER, Super NightShot or Colour Slow Shutter
mode is activated. This is not a malfunction.
(continued on the following page)
START/STOP does not operate.
The power goes off.
The image on the viewfinder screen
is not clear.
The picture does not appear in the
viewfinder.
The autofocusing function does not
work.
The SteadyShot function does not
work.
A vertical band appears when you
shoot a very bright subject.
Some tiny white, red, blue or green
spots appear on the LCD screen.
A vertical band appears when you
shoot a subject such as lights or a
candle flame against a dark
background.
— Troubleshooting —
English
Types of trouble and how to correct trouble
Ваш отзыв будет первым