- Тип техники
- Бренд
Просмотр инструкции керамического тепловентилятора Bork CH BRM 1918 SI, страница 22
Oscillating ceramic heater with thermostat CH BRM 1918 SI
22
OPERATION GUIDE
>
1 2 3
Control panel
Control panel
1. Power & Mode Knob
2. Oscillation button
3. Thermostat Knob
The heater may be operated by the manual controls located on the
heater.
1. Carefully remove the heater from the bag and the carton.
2. Make certain the unit is in the off (•) position before plugging the
heater into the power outlet.
3. The heater must be placed on a firm, level surface.
4. Plug the cord set into a 220-240V electrical outlet. Be sure plug
fits tightly in outlet. A loose fit will cause overheating and damage
the plug. Plug and cord set may feel warm during normal usage.
5. Turn the Power & Mode knob to the desired heat setting. Low
heat (1100W) is represented by the (
) and high heat (1800W)
by the (
).
6. For fan-only operation, without any heat output, turn Power & Mode
knob to the fan setting (
).
7. Press Oscillation button, the heater will oscillate back and forth.
Press it again and the oscillation will stop.
8. To disconnect heater, turn Power & Mode knob to th
e off operation
(•). Then remove the plug from outlet.
9. For heater operation, set the Thermostat Knob to the maximum
setting (
).
10. The power light will remain lit until the unit is turned off.
Ваш отзыв будет первым