- Тип техники
- Бренд
Просмотр инструкции керамического тепловентилятора Bork CH BRE 2018 SI, страница 23
23
Instruction manual
Eng
11. Pressing the Power & Mode button again and the heater will go
back to LOW heat mode. Continuing to press the Power & Mode
button will cycle the unit through LOW, HIGH, AUTO,FAN mode.
12. To turn the heater off, press the Power & Mode button for above
two seconds and turn off power switch, then remove plug from
power outlet.
Oscillation Function
This function will work in any mode. Pressing the oscillation button
(OSC.) will allow the heater to oscillate back and forth. To stop the
oscillation, press the oscillation button once more.
THERMOSTAT INSTRUCTION
1. Press the Power & Mode button until the heater is set into the
AUTO mode.
2. To adjust set temperature, rotate the Thermostat knob clockwise
to increase the desired temperature and counter-clockwise to
decrease the desired temperature.
3. When the air temperature reaches 2 degrees above the set
temperature, the heater will stop to heat at once and stop to blow
after 15 seconds.
4. When the air temperature drops 1 degree below the set
temperature, the unit will come back on.
NOTE: It is normal for the heater to cycle ON and OFF as it maintains
the set temperature.
Ваш отзыв будет первым