- Тип техники
- Бренд
Просмотр инструкции посудомоечной машины Kaiser S 45 I 70, страница 10
10
EN
Disconnecting from water supply and
sewerage
To disconnect the Aqua-Stop inlet hose, cut off
water supply by turning off the faucet, screw out
the nut of the safety inlet hose which adjusts it to
the faucet.
Put the hose into the special storage compartment
at the back of the dishwasher.
In case the free end of the hose is put directly into
the sink, pay attention to the following:
If the sink is mounted at the height of 100 cm from
the floor, the excess water cannot be drained
directly into the sink.
To drain the excess water from the hose in this
case, you need a pail or any other suitable
container which should be put below the sink at
the side of it.
INSTALLING THE DISHWASHER (MODELS
S 45I70 XL, S 60I70 XL)
Before installing the dishwasher, carry out the
following preparatory steps:
Make sure you have enough space to install the
appliance and to connect the water inlet and drain
hoses as well as the electrical cord 1.
The installation space measurements are given in
mm.
* – S 45I70 XL
* *
–
S 60I70 XL
820
600
80
100
450*
600**
1
Ваш отзыв будет первым