- Тип техники
- Бренд
Просмотр инструкции ресивера и усилителя Yamaha RX-V1065, страница 67
65 En
Troubleshooting
English
INTRODUCTION
APPENDIX
PREPARATION
BASIC
OPERATION
ADVANCED
OPERATION
Notes
• If the an error or warning message appears, resolve the problem and then run “Auto Setup” again.
• Warning message “W-2” or “W-3” indicates that the adjusted settings may not be optimal.
• Depending on the speakers, warning message “W-1” may appears even if the speaker connections are correct.
• If error message “E-10” occurs repeatedly, contact a qualified Yamaha service center.
USB
Problem Cause Remedy
See
page
The music files and
folder cannot be
browsed.
The music files and folders are stored the
locations other than the FAT area.
Place the music files and folders in the FAT area. —
You are attempting to browse directory
hierarchies of over 8 levels or a directory
with more than 500 files.
Modify the data structure on your USB storage
device.
—
This unit cannot recognize some
characters used in the file name or folder
name.
Edit the file name or folder name using a PC and then
try again.
—
The USB storage
device cannot be
recognized.
The USB storage device is not compatible
with mass storage class (except USB
HDDs).
Use a USB storage device that is compatible with
mass storage class (except USB HDDs).
—
This unit does not recognize the USB
storage device properly.
Turn this unit off and then turn on again. 19
Status message Cause Remedy
See
page
USB Connected Your USB storage device is connected. —
Disconnected Your USB storage device has been
disconnected from the USB port of this
unit.
Check the connection between this unit and your
USB storage device.
—
This unit recognizes the USB storage
device as an illegal device.
Turn this unit off and then turn on again. 19
Access Error This unit cannot access your USB storage
device.
Try another USB storage device. —
There is a problem with the signal path
from your USB storage device to this unit.
Turn off this unit and reconnect your USB storage
device to the USB port of this unit.
18, 19
Try resetting your USB storage device. —
Unable to play The data is invalid. Try another USB storage device. —
Auto Setup (YPAO)
Before Auto Setup
Error message Cause Remedy
See
page
Connect MIC! Optimizer microphone is not connected. Connect the supplied optimizer microphone to the
OPTIMIZER MIC jack on the front panel.
20
Unplug HP! Headphones are connected. Unplug the headphones. —
Memory Guard! The parameters of this unit are protected. Set “Memory Guard” to “Off”. 52
Ваш отзыв будет первым