- Тип техники
- Бренд
Просмотр инструкции видеокамеры Sony DCR-IP5E, страница 211
Troubleshooting/Поиcк и ycтpaнeниe нeиcпpaвноcтeй
211
If you run into any problem using your camcorder, use the following table to troubleshoot the
problem. If the problem persists, disconnect the power source and contact your Sony dealer. If
“C:ss:ss” appears on the screen, the self-diagnosis display function has worked. See page 217.
In recording mode
Symptom Cause and/or Corrective Actions
• The POWER switch is not set to CAMERA.
c Set it to CAMERA (p. 38).
• The tape has run out.
c Rewind the tape or insert a new one (p. 36, 56).
• The write-protect tab is set to expose the red mark.
c Use a new tape or slide the tab (p. 36).
• The tape is stuck to the drum (moisture condensation).
c Remove the cassette and leave your camcorder for at least 1
hour to acclimatize it (p. 236).
• While being operated in CAMERA mode, your camcorder has
been in standby mode for more than 5 minutes.
c Set the POWER switch to OFF (CHG) and turn on the power
(p. 39).
• The battery pack is dead or nearly dead.
c Install a fully charged battery pack.
• The viewfinder is not extended to the end.
c Pull out the viewfinder.
• The viewfinder lens is not adjusted.
c Adjust the viewfinder lens (p. 43).
• STEADYSHOT is set to OFF in the menu settings.
c Set it to ON (p. 124).
• The setting is the manual focus mode.
c Set it to the auto focus mode (p. 82).
• Shooting conditions are not suitable for autofocus.
c Adjust to focus manually (p. 82).
• The LCD panel is open.
c Close the LCD panel (p. 40).
• The contrast between the subject and the background is too
high. This is not a malfunction.
• This is called the smear phenomenon. This is not a malfunction.
• Slow shutter or low lux mode is activated. This is not a
malfunction.
English
— Troubleshooting —
Types of trouble and their solutions
START/STOP does not operate.
The power goes off.
The image on the viewfinder
screen is not clear.
The SteadyShot function does not
work.
The autofocusing function does
not work.
The picture does not appear in the
viewfinder.
A vertical band appears when you
shoot a subject such as lights or a
candle flame against a dark
background.
A vertical band appears when you
shoot a very bright subject.
Some tiny white spots appear on
the screen.
(continued on the following page)
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
qnopswalhx
27 октября 2024
Muchas gracias. ?Como puedo iniciar sesion?
0 ответов
Ответить
0