- Тип техники
- Бренд
Просмотр инструкции акустики Yamaha NS-9900, страница 2
2 En
When placing the speakers, be sure to use the stands to
increase stability.
• The provided stands are in two types. Two stands are
for the right side and others are for the left side. Attach
each stand to the proper position on the bottom of the
speaker by following the figure below.
• When attaching the stands to the speaker, have another
person support it.
• To attach the stands to the speaker, be sure to lay down
the speaker while the front is facing up. We recommend
using a blanket or cushion (thickness of 3 cm or more)
to raise the speaker from the floor.
Use the 8 specified holes located on the base of the speaker.
How to attach
1 Put a screw through a washer, then through the
inner hole of the stand, and screw it into the outside
hole of the speaker. Do not tighten too much at this
point.
2 Put a screw through a washer, then through the
outer hole of the stand, and screw it into the other
hole on the base of the speaker.
3 Tighten both of the screws firmly.
4 Attach a pad to the bottom of the end portion of the
stand.
5 Attach the other stands to the other corners of the
base of the speaker in the same way and confirm
that all 4 stands have been firmly attached.
Be careful not to apply force to the side of the speaker,
otherwise the speaker may fall causing damage to the
speaker or personal injury.
SUPPLIED ACCESSORIES
R
L
Speaker cable
(4 m) x 1
Stand
(R x 2, L x 2)
Screw
(M4, 25 mm)
x 8
Non-skid pad
(1 set: 4 pcs)
Washer x 8
ATTACHING THE STANDS
Notes
(L) (R)
(R) (L)
Front
Back
View from the bottom of the speaker
Note
R
Outer hole
Inner hole
Ваш отзыв будет первым