- Тип техники
- Бренд
Просмотр инструкции ресивера и усилителя Yamaha RX-V665, страница 65
63 En
Troubleshooting
English
INTRODUCTION
APPENDIX
PREPARATION
BASIC
OPERATION
ADVANCED
OPERATION
E-9:USER CANCEL “Auto Setup” was cancelled due to an
inappropriate user operation.
Run “Auto Setup” again. 19
E-10:INTERNAL ERROR An internal error occurred. Run “Auto Setup” again. 19
After Auto Setup
Error message Cause Remedy
See
page
W-1:OUT OF PHASE Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
Check the polarities (+, –) of the displayed speaker.
If they are correct, the speakers work properly even
when this message is displayed.
11
W-2:OVER 24m (80ft) The distance between the speaker and the
listening position is over 24 m (80 ft).
Bring the speaker within 24 m (80 ft) area around the
listening position.
—
W-3:LEVEL ERROR The difference of volume level among
speakers is excessive.
Recheck the speaker positions and make sure all
speakers are placed in a similar environment.
—
Check the polarities (+, –) of the speakers. 11
We recommend that you use speakers with the same
or similar specifications.
—
Adjust the output volume of the subwoofer. —
W-4:CHECK PRNS Presence speakers were not detected
during measurement with “Extra SP
Assign” set to “Presence.”
Check the presence speaker connections and perform
measurement again.
If presence speakers are not connected, set the
“Extra SP Assign” to other than “Presence.”
44
If presence speakers are connected, set the “Extra SP
Assign” to “Presence,” and retry Auto Setup.
44
Error message Cause Remedy
See
page
Ваш отзыв будет первым