- Тип техники
- Бренд
Просмотр инструкции ресивера и усилителя Yamaha RX-V563, страница 85
83 En
Troubleshooting
English
ADDITIONAL
INFORMATION
After AUTO SETUP
• If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “AUTO SETUP” again.
• If a warning message “W-1”, “W-2”, or “W-3” appears, corrections are made, but they may not be optimal.
• If an error message “E-9” occurs repeatedly, please contact a qualified Yamaha service center.
Warning message Cause Remedy
See
page
W-1:OUT OF PHASE
Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
Check the speaker connections for proper
polarity (+ or –).
12
W-2:OVER 24m (80ft)
The distance between the nearest speaker
and the furthest speaker is out of adjustable
range.
Bring the speaker closer to the listening
position.
—
W-3:LEVEL ERROR
The difference of volume level among
speakers is excessive. (No level correction
is made.)
If “SWFR:TOO LOUD” or “SWFR:TOO
LOW” appears, adjust the output volume of
the subwoofer.
26, 61
Readjust the speaker installation so that all
speakers are set in locations with similar
conditions.
—
Check the speaker connections.
11
Use speakers of similar quality.
—
Notes
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
Посетитель_Ql11wb
31 мая 2022, Санкт-Петербург
подключить проигрыватель пластинок
0 ответов
Ответить
0