- Тип техники
- Бренд
Просмотр инструкции утюга Philips GC3220, страница 10
Solution
Check the mains cord, the plug and
the wall socket.
Set the temperature dial to the
required position.
Fill the water tank (see chapter
'Preparing for use').
Set the steam control to a position
between 1 and 4 (see chapter 'Using
the appliance').
Select an ironing temperature that is
suitable for steam ironing (2 to
MAX). Put the iron on its heel and
wait until the amber temperature light
has gone out before you start ironing.
Continue ironing in horizontal position
and wait a while before using the
(vertical) shot-of-steam function again.
Select an ironing temperature that is
suitable for steam ironing (2 to
MAX). Put the iron on its heel and
wait until the amber temperature light
has gone out before you start ironing.
Press the cap until you hear a click.
Rinse the water tank and do not put
any additive in the water tank.
Set the temperature dial to a
temperature suitable for steam ironing
(between 3 and MAX). Put the
iron on its heel and wait until the
amber temperature light has gone out.
Use the Calc-Clean function one or
more times (see chapter 'Cleaning
and maintenance').
Move the iron slightly to deactivate
the safety shut-off function.The light
goes out.
Empty the water tank and set the
steam control to position 0 after use.
Store the iron on its heel.
Possible cause
There is a connection problem.
The temperature dial has been set to
MIN.
There is not enough water in the
water tank.
The steam control has been set to
position 0.
The iron is not hot enough and/or the
drip-stop function has been activated.
The (vertical) shot-of-steam function
has been used too often within a very
short period.
The iron is not hot enough.
The cap of the filling opening has not
been closed properly.
An additive has been poured into the
water tank.
The iron is not hot enough.
Hard water forms flakes inside the
soleplate.
The safety shut-off function has
switched the iron off (see chapter
'Features').
The iron has been put in horizontal
position with water still left in the
water tank.
Problem
The iron is plugged in but the soleplate
is cold.
No steam.
No shot of steam or no vertical shot of
steam.
Water droplets drip onto the fabric.
Flakes and impurities come out of the
soleplate during ironing.
The red light blinks (type GC3260
only).
Water drips from the soleplate after
the iron has cooled down or has been
stored.
ENGLISH10
Troubleshooting
This chapter summarises the most common problems you could
encounter with your iron. Please read the different sections for more
details. If you are unable to solve the problem, contact the Customer
Care Centre in your country.
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
Гость
07 октября 2019, Москва
как разобрать утюг
0 ответов
Ответить
0