- Тип техники
- Бренд
Просмотр инструкции пылесоса Vitek VT-1847 R/B, страница 7
7
ENGLISH
coverings (24) or crevice nozzle (25) and
connect it to the telescopic extension
tube (Pic. 4).
USING BRUSHES AND NOZZLES
Turbo brush for floor/carpets (1)
Use turbo brush (1) to clean the floor, car-
pets and covers with long and short nap, it
is ideal for cleaning the wool out from the
carpets. Cylinder brush with coarse nap is
rotated by the air flow, its nap brushes the
wool and removes small dirties out of the
carpet nap very effectively.
Notice: in order to avoid a carpet dam-
age caused by the brush rotation, do not
use the turbo brush for cleaning the car-
pets with very long nap, more then 15 cm
length. Do not touch the electrical wires by
the brush. After the cleaning is completed
switch the appliance off immediately.
Floor/carpet brush (22) (Pic.5-6)
Turn the switcher on the brush to the re-
quired position (depending on the type of
the surface you need to clean).
Small brush (23)
This nozzle is intended for collecting the
dust from the surface of the furniture. The
nozzle nap prevents the polish face of your
furniture from damages.
Nozzle for cleaning the furniture cover-
ings (24)
The nozzle is intended for cleaning the cov-
erings of your furniture.
Crevice nozzle (25)
This nozzle is intended for cleaning of the
radiators, crevices, corners and spaces be-
tween sofa pillows.
Operating instructions
Before using the appliance, unwind a suf-
ficient length of the power cord and insert
the plug into the wall outlet. Yellow mark
on the power cord indicates the maximum
length of the cord.
Do not expend the cord beyond the red
mark.
Attention!
Always switch the appliance on only if the
dust collecting container (6) is installed,
and the filters (18, 19) are installed inside
the container.
1. Push ON/OFF button (9) to switch the
appliance on.
2. While operating you can adjust the suc-
tion power by turning the regulator (10).
3. After the cleaning is completed press
ON/OFF button (9) to switch off the vac-
uum cleaner and then unplug its power
cord from the wall outlet.
4. To rewind the power cord press rewind-
ing button (13) and hold the winding
cord by the hand to escape whipping
and damages.
Maintenance
Detaching dust collecting container (6)
and removing the dust and trash from it
(Pic. 7, 8)
- Switch off the vacuum cleaner and un-
plug the power cord from the wall outlet.
- Press the button (8), and take out the
dust collecting container (6) holding the
handle (7).
- Open the lower cap (21) of the dust col-
lecting container by pressing the locking
button (20).
- Remove the dust and trash out of the
container.
Notice
- It is recommended to clean the container
every time after using the appliance.
- If the dust collecting container is full, the
indicator (11) is flashed to remind that
you should clean the dust collecting con-
tainer and filters.
1847.indd 71847.indd 7 06.03.2009 12:15:5106.03.2009 12:15:51
Ваш отзыв будет первым